Welcome to Iprece!

30 years manufacturing of RF, Microwave components and modules
✕
noun-comparators-ic-2574929 (1)
Categories
noun-comparators-ic-2574929 (1)
Categories
✕

Applications

  • Cellular Mobile Phones
  • Test and Measurement
  • Instrumentation
  • Aircraft and Missile
  • Radar
  • Computer Networks/LANs
  • Base Stations
  • Microwave Components (Filters, Diplexers)

Features

  • Connectors are suitable for use in applications where safety can’t be compromised such as test and measurement, and medical equipment.
  • Accommodates a wide range of popular coaxial cables.
  • Screw-on coupling mating.
  • Available in crimp terminations to provide for low-cost installation.
  • Interface according to IEC 169-17, MIL-STD-348B

Special Notice

  • The specification is listed below for information. All dimensions are fully complied with Military requirements
  • Iprece provides commercial grade connectors, and environmental requirements we can test in-house.
  • For electrical and mechanical test, we can support most of it in-house.
  • If you have any question, please contact our QA Team.

Electrical

Impedance 50Ω / 75Ω
Frequency Range 0 to 11 GHz / 0 to 1 GHz
VSWR                      ≤1.3    (straight connector)
≤ 1.35 (right angle connector)
RF Leakage ≥60 dB
Dielectric Withstanding Voltage 1500 V rms
Voltage Rating ≥500 V rms (depending on cable)
Inner Contact Resistance ≤1.5 mΩ
Outer Contact Resistance ≤1  mΩ
Insulation Resistance ≥5 GΩ

Mechanical

Mating 7/16 – 28UNEF Screw-on Coupling
Connector Durability ≥500 Cycles (for beryllium copper female contact only)
Recommended Mating Torque 4.1 lbs ~ 6.1 lbs
Coupling Nut Retention Force ≥101.2 lbs
Cable Retention Force ≥ 12.1 lbs (for RG316)
≥ 28.7 lbs (for RG58)
≥ 38.3 lbs (for RG59)

 

Environmental

Temperature Range -65° C to 165° C
Corrosion (Salt Spray) MIL-STD-202, Method 101, Cond. B
Vibration MIL-STD-202, Method 204, Cond. B
Thermal Shock MIL-STD-202, Method 107, Cond. B
Mechanical Shock MIL-STD-202, Method 213, Cond. G

Material

Parts Name Material Plating
Body Brass Nickel or Gold
Inner Contact Male: Brass
Female: Brass, Phosphor Bronze or Beryllium Copper
Nickel or Gold
Insulator PTFE or Delrin None
Gasket Silicone Rubber, Rubber None
Crimp Ferrule Annealed Copper Same as Body

Note: Other Material/Finish is Available on Request.

Reviews

There are no reviews yet.

Be the first to review “TNC Bulkhead Rear Mount, O-Ring Jack, Crimp Type 50/75 ohm”

Your email address will not be published. Required fields are marked *